Peter,
Du bist hier unter T&T gelandet, da sollte man nur Tips geben. Aber ein Mod wird es schon passend verschieben in das E32 Forum.
Sender / Klappholz kannst Du testen:
Checking if your IR remote funtions:
If you are doubting wheter your IR remote is working try holding the remote about 10 mm from a reflecting surface. A mirror should do just fine. Push the open button. After the intervall blinking the LED will remain on. Now try holding the remote close to a non reflecting surface. Press the open button. Now the LED should go off after the intervall blinking.
Send in by Erich
You can also check the function of any IR-Remote controller by watching the led, while activating it, trough a digital camera. You don't have to take a picture, the LED function can be seen as a white light on the camera LCD, normal mobile camera works as well.
Send in by Timo Saarela
----------------------
In denke, dass Du das Ding wieder initialisiert hast. Wenn nicht,
Programming the IR remote:
To reprogram a new IR remote or your old one after replacing the batteries:
1. Turn the ignition to position 2.
2. Hold the IR transmitter on the DWA led in the center of the fresh air grill.
3. Press button 1 untill the transmitter LED begins to flash (after about 2 seconds). Now your all done.
Within 15 minutes any other remotes to be used with the car must be initialised. There is a max of 4 remotes.
|