Sie sind nicht angemeldet! Jetzt interner Link kostenlos im Forum registrieren, weniger Werbung sehen, aktiv teilnehmen und weitere Vorteile nutzen! Diese Website nutzt Cookies. Bitte beachten Sie unsere interner Link Datenschutzerklärung.
  Start » Forum Impressum/Datenschutz | Site-Map
7-forum.com   ModelleForummein.7erService


Forumsfunktionen

BMW 7er, Modell E32
 Varianten
 Detail-Infos
 Interaktiv
- Anzeige -

Zurück   BMW 7er-Forum > BMW 7er Modelle > BMW 7er, Modell E32



Antwort
 
Thema teilen Themen-Optionen Ansicht
Alt 04.07.2020, 22:40   #31
Andrew1Q
Neues Mitglied
 
Registriert seit: 25.06.2020
Ort: Ukraine
Fahrzeug: BMW E32-735i (02/1990)
Standard

Thanks in advance ! May I use Dextron 3 not synthetic oil ? What will happen if kick down switch not grounded of rust floor ? Will car go to limp mode ?

Geändert von Andrew1Q (04.07.2020 um 22:46 Uhr).
Andrew1Q ist offline   Antwort Mit Zitat antworten
Alt 04.07.2020, 23:46   #32
dansker
Erfahrenes Mitglied
 
Benutzerbild von dansker
 
Registriert seit: 22.02.2012
Ort: DK
Fahrzeug: Mercedes W203, 1,8 Kompressor Coupe +Honda Magna 750V4
Standard

Doch Dexron 3 ist Vollsynthetisch. Besonders gut für die 4HP22/24, da diese eigentlich eine sehr geringe Ölmenge Beinhalten und deshalb das Öl sehr warm werden kann. Dexron 3 hat einen Flammpunkt von 240 Grad, wogegen Dexron 2 nur einen Flammpunkt bis 120 Grad hat.
__________________
Es ist schon erstaunlich, wie der Mensch an seinem Leben hängt, obwohl er es so hasst.
dansker ist offline   Antwort Mit Zitat antworten
Alt 05.07.2020, 02:51   #33
Erich
Shogun
 
Benutzerbild von Erich
 
Registriert seit: 19.07.2002
Ort: Joso
Fahrzeug: E32 750iL 11/88
Standard

Zitat:
Zitat von Andrew1Q Beitrag anzeigen
What will happen if kick down switch not grounded of rust floor ? Will car go to limp mode ?
no, it will not go into limpmode, I explained that already on Bimmerforums to you, your car has no EML, see here Interner Link) https://www.7-forum.com/forum/showth...light=kickdown
you can test it: Schau dir den Kickdown-Schalter an, der sitzt als Gummiblock hinterm Gaspedal, dort sollen 5 Volt sein, und wird beim drücken auf Masse geschaltet. Das kannst am Getriebe-Steuergerät Pin 2 Kabel grün/gelb Messen.
----
So measure on the transmission control unit pin 2 cable green/yellow
Erich ist offline   Antwort Mit Zitat antworten
Alt 05.07.2020, 09:41   #34
Andrew1Q
Neues Mitglied
 
Registriert seit: 25.06.2020
Ort: Ukraine
Fahrzeug: BMW E32-735i (02/1990)
Standard

Do you know what engine oil pressure should be at PSI gauge if installed to somewhere at cylinder head ?
Andrew1Q ist offline   Antwort Mit Zitat antworten
Alt 05.07.2020, 13:15   #35
Erich
Shogun
 
Benutzerbild von Erich
 
Registriert seit: 19.07.2002
Ort: Joso
Fahrzeug: E32 750iL 11/88
Standard

The German repair manual from Bucheli for the E32 series has following info for the oil pressure
for the M30B30 and M30B35
oil pressure in idle 0.5-2.0 bar
oil pressure at max RPM 4.0-6.0 bar.
radial tolerance outer rotor/pump housing 0.1-0.15mm
axial play
rotor/pump housing 0.04-0.1mm
space inner/outer rotor 0.12-0.20mm
length of the over pressure spring without tension 68mm
Erich ist offline   Antwort Mit Zitat antworten
Antwort


Aktive Benutzer in diesem Thema: 1 (Registrierte Benutzer: 0, Gäste: 1)
 
Themen-Optionen
Ansicht

Forumregeln
Es ist Ihnen nicht erlaubt, neue Themen zu verfassen.
Es ist Ihnen nicht erlaubt, auf Beiträge zu antworten.
Es ist Ihnen nicht erlaubt, Anhänge hochzuladen.
Es ist Ihnen nicht erlaubt, Ihre Beiträge zu bearbeiten.

BB-Code ist an.
Smileys sind an.
[IMG] Code ist an.
HTML-Code ist aus.
Gehe zu

Ähnliche Themen
Thema Autor Forum Antworten Letzter Beitrag
E32-Teile: Automatikgetriebe 740i e32 mit WANDLER! 7er Bmw freund Biete... 0 08.05.2011 21:09
Ablassschraube Kühlflüssigkeit M70 ? sidoon BMW 7er, Modell E32 1 06.08.2009 11:55
Motorraum: Gewindemaß Öl Ablassschraube mutsy-man BMW 7er, Modell E38 2 23.08.2008 21:32
Motorraum: 750 Differential Ablassschraube!??? Florian.e BMW 7er, Modell E32 7 06.09.2005 09:04


SiebenPunktSieben - das siebte 7er-Jahrestreffen - jetzt den Foto-Bericht anschauen!
Alle Zeitangaben in WEZ +1. Es ist jetzt 20:37 Uhr.

7-forum.com Forum Version 6 powered by vBulletin
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Mit der Nutzung des Forums erklären Sie sich mit den Nutzungsbedingungen einverstanden.
 

 
www.7-forum.com · Alle Rechte vorbehalten · Dies ist kein Forum der BMW Group