hier noch mal das resetten mit dem Draht pin 7 und 19
http://bmwe32.masscom.net/johan/tips...ps_tricks.html
Resetting the SI:
To reset the service indicator after performing an oil-service or an inspection:
1. With the ignition off connect pin 7 (SI reset) with pin 19 (gnd). Remember to fuse this wire or to use a resistor just to be safe.
2. Turn the ignition to position 2.
3. Pull the wire out after about 5 seconds to get an oil reset or 10 seconds for an inspection reset.
3. Now replace the cap on the diagnostic connector.
4. Turn off the ignition.
Wie gesagt, beim Grauen KI sollte man mal die Elkos erneuern und auch mal alle Loetstellen untersuchen.